Tired of the Pi problem?  MANTA M5P motherboard is a 5 driver, 32-bit printer motherboard for Klipper firmware.

We conveniently sell the for this board, you can find it here.

The Manta M5P is a great choice for Klipper printers like the Voron V0, but also for other printers that use 5 steppers like an Ender 3 (running Klipper)

Manta M5P

• Installed with 32-bit 64MHz ARM Cortex-M0 STM32G0B1RET6 chip, more stable and faster.
• Designed with the same connector with Raspberry Pi, giving you a confident connection with all versions of CM4,definitely, CB1. Also, a screw-reinforced installation is also avaliable.
• It has rich expansion ports, can support various expansion modules, such as BL Touch, LCD screen, RGB light, auto shutdown, etc.
• TPS5450-5A Power Chip The 5A output perfectly matches the power supply need of Raspberry Pi.
• Selectable CNC fan voltage, 5V/12V/24V.
• Added eFuse circuit protection. It will faster disconnected on overload, and automatically reset if the overload is gone, which will greatly reduce the motherboard burnout caused by short circuits or ignition.
• Reserved Can Bus port can be connected with EBB CAN, which will simplify the wiring and provide strong  anti-interference ability.